Precautions for Ash Cleaning of Biomass-Fired Boilers
2020/04/08
Precautions for Ash Cleaning of Biomass-Fired Boilers
During boiler operation, ash cleaning should be performed once a day. Open the ash cleaning door on the boiler body and remove the accumulated ash in the combustion chamber. In particular, large clinkers and sandy slag produced after combustion should be removed frequently and promptly; otherwise, they will seriously affect normal combustion and increase fuel consumption.
After one week of operation, the heat recovery ash removal trough should be cleaned.
After one month of operation, the boiler should be inspected. Any leaks found at instruments, valves, flanges, etc. should be repaired. The water level probe should be taken out for descaling, and the dirt inside the water level glass tube should also be cleaned. At the same time, check whether the smoke box is tightly sealed.
Every 3 to 6 months of operation, the boiler should be shut down for a comprehensive inspection and maintenance. In addition to the above work, the following tasks should also be carried out:
- Open all furnace doors and ash cleaning ports, inspect the smoke tubes, and remove soot and dirt from inside the tubes.
- Remove scale and sludge from inside the boiler drum and rinse with clean water.
- Inspect both the internal and external parts of the boiler, including welds on pressure‑bearing components and whether there is any corrosion on the steel plates. If serious defects are found, they should be repaired immediately. If the defects are not serious, do not leave them until the next shutdown; if any suspicious points are detected, they should be eliminated without delay.